Organization / Terms / ceramic mold manufacturer

The process of a ceramic mold manufacturer: Models made of clay, wood or plaster must be coated with 2 or 3 layers of thinned down orange shellac. First you must study the object from which you are to make the mold, to establish the Ceramic mold manufacturer line: Draw a line on the object with a dye-marking felt tip pen. Place the object on your Work Board so your parting line is somewhat parallel to your work surface. Proceed to Clay-Up with water base modeling clay around the object to your parting line, extend out for one inch from the widest points.

When clay is all in place, smooth and leather hard, square off clay as shown. Using a soft brush, apply two thin coats of Orange Shellac over the object and the top surface of the clay parting line. After 15-20 minutes, apply talcum powder, dusting lightly. Apply Parting Agent with a soft brush covering the entire surface. Dry your brush and pick up all excess Parting Agent, leaving a very slick surface on the object and parting line clay. Ceramic mold manufacturer casting mold Prepare your casting boards, wiping each with Parting Agent on front surface and edges.

Assemble as shown with "C" Clamps. With wooden tool, seal edges where clay parting line meets the insides of the board as shown. For the size of the ceramic mold manufacturer object shown in these drawings and the apparent bulk of parting line around the model, we will use the following proportions: With your 1 gallon plastic jar, weigh out 1 1/2 lbs. of No.1 Pottery Plaster. If you need more information please contact YTC ceramic mold manufacturer